A lift can generate motor, drive, guide, brake and structural vibration at different moments in its journey. Inside a nearby room, these contributions may arrive through walls, floors, fixings and airborne paths. Treating the nearest surface without identifying the dominant route can leave the important mechanism untouched.
The machine is only the beginning of the chain
Lift sound is produced by operating equipment, but what a resident hears depends on how that energy couples into the shaft and building. Vibration can travel through supports and structural connections before being radiated as sound by a room surface.
Airborne sound can also pass through doors, gaps and enclosures. The balance changes with lift speed, load, travel direction, braking and the location of the receiving room.
What the 2026 study tested
A peer-reviewed Journal of the Acoustical Society of America study examined a domestic or 'villa' lift whose noise was concentrated mainly between 20 and 500 Hz. The researchers first used coherence and energy analysis to identify the primary source and dominant propagation direction.
They then developed an active noise-control system using a learned complex-spectrum model. The reported reductions at two operating speeds were substantial in the test configuration, including A-weighted reductions of about 7.5 dB.
The result is not a retrofit promise
Those figures apply to the studied lift, room and control arrangement. Active control depends on sensor positions, loudspeaker authority, processing delay, stability and the repeatability of the sound field. A different installation may not achieve the same result.
The study is therefore more useful as evidence for a method than as a product claim: establish the dominant transmission path, reduce the problem to a controllable route where possible, and verify performance under the operating conditions that matter.
Low frequency changes the investigation
Energy in the 20–500 Hz range can involve both audible low-frequency sound and structural vibration. Room modes may make the sound stronger at some positions, while a wall or floor can radiate differently across its surface.
A single broadband reading may not separate motor harmonics, mechanical events and structure-borne radiation. Time histories linked to lift operation, one-third-octave or narrow-band spectra and vibration measurements can make the pattern clearer.
Passive controls still come first in many homes
Active control may be appropriate for a repeatable, well-defined low-frequency field, but it does not replace good mechanical and structural design. Isolation of machinery, resilient connections, shaft construction, door seals, alignment and maintenance may address the source or path more directly.
Adding absorption inside a room may reduce reverberant sound but will not necessarily stop structure-borne energy entering the room. Equally, treating the lift enclosure may not repair a rigid bridge through the building structure.
A practical diagnostic sequence
Before discussing treatment, I would link the measured event to the lift cycle and separate the likely paths.
- Record start, travel, stopping, braking and door events separately.
- Measure sound and, where relevant, vibration at the same time.
- Compare spectra and coherence at suspected source and receiver positions.
- Check supports, fixings, shaft interfaces, doors and service penetrations.
- Test more than one room position where low-frequency variation is likely.
- Verify any control at different speeds, loads and directions of travel.